Latest bootloader_Latest patch Vu+Solo CLONE

Please read the steps few times before starting.You better do not disconnect the rs232 cable and small board.Use windows XP and DO not use a usb2serial it won't work

- Step 1
Keep the box Powered OFF

- Step 2 Updating of Secret chip
Please make update of the secret chip.Use renewaes solo software (secupd111230.exe) to update it.Connect RS232 small board with RS232 cable to computer COM port.Then run secupd111230.exe (please take a note of the right COM port) , and open solo scret.bin file and THEN Power ON solo receiver.You will see update progress bar- Wait till it finish and then close it.Power OFF the box.

- Step 3 Updating of Flash chip
Box remaining in OFF position.
Please make update flash chip.Connect RS232 small board with RS232 cable to computer COM port(if you had remove it by any reason). Start renewflash.exe, and choose upflash120227.bin file and hit the UPDATE button, THEN Power ON solo receiver. You will see update progress bar- Wait till it finish and then close it.Leave the box as it is.

- Step 4 -Erase Flash chip.
Connect RS232 small board with RS232 cable to computer COM port(if you had remove it by any reason).Run ERASE126.exe and click ERASE button.Power OFF and then Power ON. Do NOT do reset of the box.
You will see update progress bar- Wait till it finish and then close it.Power OFF the box.
Those are all steps for the updates

- Step 5 Loading CFE boot loader
Use cfe_solo_2.0 file -load it to a usb pen drive and then, make update.

- Step 6 Flashing Image
Choose your Favourite image load it to the usb pen drive and then ,make update.


Thanks to Ferrari Team.